Panasonic DBS-576 Technical Manual page 296

FF2: Trunk Programming (Analog E&M Tie)
Introduction
DTMF After Answer (Link Control)
(all CPCs) - Version 1.0 or higher
For calls on this trunk using pushbutton (DTMF) SLT phones, set whether
0
DTMF signals can be sent through the system after the called party answers.
System
Configuration
FF1
System
BSSC: E&M Tie Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
FF2
Trunks
Notes:
Set this address to "1" (One-Way Link) to prevent double-dialing -- making an outgoing call on the
FF3
same trunk after the called party hangs up, thus bypassing TRS restrictions.
Extensions
Related Programming:
FF4
FF-/Soft Keys
CO Dial Tone Simulation
FF5
(all CPCs) - Version 1.0 or higher
Groups
Set whether the system sends a simulated CO dial tone to an extension using this trunk
(important for DID Wink-Start trunk signaling).
FF6
TRS/ARS
BSSC: E&M Tie Trunk Position
FF7
Applications
Notes:
FF8
Maintenance
Set to "1" (Send) if the CO doesn't support dial tone (typical in U.K.).
Related Programming:
Trunk Signal Type (pg. 2-38)
Appendix A
Appendix B
Page 2-48
FF2 0 BSSC
FF2 0 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
FF2 0 BSSC 01 00 Hold (0-5) Hold
DBS 576 (USA) issued 05/20/98
02 06 Hold (0 or 1) Hold
0=Two-Way Link: DTMF path open
both ways. (default)
1=One-Way Link: No DTMF signaling
after the called party answers.
02 07 Hold (0 or 1) Hold
0=Do not send simulated CO dial tone
to extension. (default)
1=Send simulated CO dial tone.
Section 400-Programming
$ 
54 !!,
$ %
# % "! %
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B