HP 8360 User Handbook Manual page 332

l
l
DIAGnostics:TEST:LOG[:STATe] ON|OFF|l|O
Selects and queries the raw data logging ON/OFF switch. Both
commands are executable in selftest mode.
After *RST, the setting is 0.
DIAGnostics:TEST:LOOP ON|OFF|l|O
l
DIAGnostics:TEST:LOOP?
l
Selects and queries the test looping ON/OFF switch. Both
commands are executable in selftest mode.
After "RST, the setting is 0.
DIAGnostics:TEST:NAME? [<num>]
l
Queries the name of a selftest by number. If the number is not
specified then an array of all the selftest names is returned.
DIAGnostics:TEST:POINts?
l
Returns the number of points of selftest that is output using
DIAGnostics:TEST:NAME? or DIAGnostics:TEST:RESult?.
DIAGnostics:TEST:RESult? [<num>]
l
Queries the result of a selftest, by number. The response is a string
containing either Passed, Failed, or NotRun. If <num> is missing,
an array of selftest results are returned.
l DIAGnostics:TINT? <num>
A test feature that returns the value passed to it. This is used to test
the HP-IB interface.
l
l
Sets and queries the display ON/OFF switch.
After *RST, the value is 1.
FM:COUPling ACiDC
l
FM:COUPling?
l
Sets and queries the FM input coupling mode.
The *RST value is AC.
l
l
Sets and queries the peak FM deviation (in Hz) when the internal
FM generator is used. After 'RST, the value is 1 MHz.
FM:FILTer:HPASs <num>[freq suffix'lMAXimumlMINimum
l
FM:FILTer:HPASs? [MAXimumlMINimuml
l
Sets and queries the FM AC bandwidth. There are only two
HP 8360
User's Handbook