How To View Or Change A Language Selection From The Front Panel; How To Select A Language On A Synthesizer Without A Front Panel - HP 8360 User Handbook Manual

Language Selection
Note
Remember
Note
3-6 INSTALLATION
You can operate the synthesizer using one of three external interface
languages: SCPI, Analyzer language, or CIIL (Option 700).

How to View or Change a Language Selection from the Front Panel

To set a programming language from the front panel, the instrument
language on the rear panel HP-IB switch (Ll, L2, and L3 Figure 3-2)
The HP-IB menu provides access to the synthesizer's programming
language:
1. Press SYSTEM (NIENU).
Menu.
2. Select HP-IB
3. The synthesizer displays the three language
softkeys: Programming Language SCPI ,
Programming Language Analyzr,and
the selected language.
4. Select the desired softkey.
If the synthesizer displays Rear panel HP-IB language must be 7
(111) in order to change current language (=XxX>, the address
on the rear panel HP-IB switch (Figure 3-2) is set to something other
than 7 (all 1s).
If the synthesizer does not have Option 700, and you select
Power Up Language CIIL , the instrument displays
*****OPTION NOT INSTALLED*****.
5. The asterisk indicates the selected softkey, and the synthesizer
displays LANG: XXXX, ADRS=XX, REV da mo yr.

How to Select a Language on a Synthesizer without a Front Panel

If your synthesizer does not have a front panel, set the rear panel
HP-IB switch (F g i ure 3-2) for the language you want. (See Table 3-l
for language addresses.)
Table 3-1. Language HP-IB Addresses
Language HP-IB Address
Analyzer
(Decimal)
0
1
2
Specifications