Chassis Kits; Rack Mount Slide Kit (Option 806); Installation Procedure; Rack Mount Slide Kit Contents - HP 8360 User Handbook Manual

Rack Mount Slide Kit
(Option 806)
CAUTION
3-10 INSTALLATION
Option 806 synthesizers are supplied with rack mount slides and the
necessary hardware to install them on the synthesizer. The following
table itemizes the parts in this kit.
Table 3-3. Rack Mount Slide Kit Contents
Quantity
Rack Mount Kit (Includes the following parts)
2 Rack Mount Flanges
8 Screws
Slide Kit Jncludes the following parts)
2 Slide Assemblies
Screws (Inner Slide Assembly)
4
8 Screws (Outer Slide Assembly)
Nuts (Outer Slide Assembly)
8
Slide Adapter Kit
Adapter Brackets
4
4 Adapter Bar
Screws (Bracket to Bar)
8
8 Nuts (Bracket to Slide Assembly)
Ventilation Requirements:
cabinet, the convection into and out of the instrument must not be
restricted. The ambient temperature (outside the cabinet) must be
less than the maximum operating temperature of the instrument
by 4 "C for every 100 watts dissipated in the cabinet. If the total
power dissipated in the cabinet is greater than 800 watts, then forced
convection must be used.

Installation Procedure

1. Refer to Figure 3-3. Remove handle trim strips.
2. Remove four screws per side.
3. Using the screws provided, attach the rack mount flanges to the
outside of the handles.
4. Remove the side straps and end caps.
5. Remove the bottom and back feet and the tilt stands.
Description
(NON-HP,
includes the following parts)
When installing the instrument in a
Specifications