Toro Groundsmaster 300 Series Service Manual page 203

11. Slide a new retaining ring on the axle shaft and
support the shaft and ring in a suitable press (Fig. 14).
Press the retaining ring firmly against the bearing.
12. Put a light coating of No. 1 Permatex on the outside
diameter of a new grease seal (surface that contacts the
axle housing). Install the new seal to a depth of 1.218
in. into the housing (Fig. 15, 16). After the seal has been
assembled, put grease on the lip of the seal.
®
Groundsmaster 300 Series Page 7 - 7
Figure 14
Figure 15
1.218" sea l
installation depth
Figure 16
Repairs