Toro Groundsmaster 300 Series Service Manual page 299

Adjustments
Steering Stop Bolt Adjustment
The rear axle steering stop bolts help prevent over–trav-
el of the steering cylinder in case of impacts on rear
wheels. When the steering cylinder is fully extended, a
gap of 1/16" (1.6 mm) should exist between left side bev-
el gear case casting and stop bolt (Fig. 1). When the
2
steering cylinder is fully retracted, a gap of 1/16" (1.6 1
mm) should exist between right side bevel gear case
casting and stop bolt.
Figure 1
1. Steering stop bolt 2. Bevel gear case (LH)
Groundsmaster 328–D Page 10.1 – 3 4WD Rear Axle (Rev. G)
(Dae Dong Axle)