11. Put the drive plate on a clean lint-free surface with
the eleven tapped holes facing up. Put the rotor set on
top of the drive plate with the five pin holes facing up.
Rotate the stator until the eleven hex socket head screw
relief slots are aligned with the tapped holes in the drive
plate (Fig. 73).
12. Apply a small amount of clean multi-purpose grease
to the spacer and insert it into the drive slot in the rotor
(Fig. 74). The grease will aid in retaining the spacer
during other assembly procedures.
13. Put the commutator on top of the rotor. Be sure the
correct surface (Fig. 75) is towards the rotor.
®
Groundsmaster
300 Series
Page 8 - 39
Figure 73
Figure 74
Figure 75
Repairs