Toro Groundsmaster 300 Series Service Manual page 213

7. Support the drive pinion in a suitable press (Fig. 41).
8. Install the outer pinion spacer with the chamfer to-
wards the pinion splines and install the new outer pinion
bearing cone (Fig. 42).
9. With a hollow press sleeve of proper diameter, press
on the outer bearing cone race until the drive pinion
seats in the carrier and a slight drag is noticed when the
gear is rotated by hand (2-13 in.-lb. torque to rotate)
(Fig. 43). If the drag is to severe, tap the pinion shaft
with a soft mallet until the drag is reduced.
®
Groundsmaster 300 Series Page 7 - 17
Figure 41
Figure 42
Figure 43
Repairs