Toro Groundsmaster 300 Series Service Manual page 207

8. To remove the side gears and pinion mate gears,
rotate the side gears. This will allow the pinion mate
gears to turn to the opening of the case (Fig. 26).
Remove the pinion mate gears and the spherical wash-
ers behind the gears.
9. Remove the eight side cover capscrews. Remove the
the side cover from the carrier assembly (Fig. 27). Clean
the gasket material from the mating surfaces before
reassembly.
10. If unit has an expansion plug, remove it by driving a
pointed punch through the plug about 3/8 inch (10 mm)
from the outer edge. When the hole is large enough,
insert a large screwdriver through it and pry the plug
outward (Fig. 28).
®
Groundsmaster 300 Series Page 7 - 11
Figure 26
Figure 27
Figure 28
Repairs