Toro Groundsmaster 300 Series Service Manual page 260

14. Align the five holes and press the five alignment pins
in place (Fig. 76).
IMPORTANT: Make sure the five alignment pins are
pressed below the surface of the commutator.
15. Put a few drops of oil into each recess in the
commutator (Fig. 77).
16. Put the commutator ring (either side up) on top of
the stator (Fig. 78). Align the commutator ring screw
recesses with the stator screw slots.
Repairs Page 8 - 40
Figure 76
Figure 77
Figure 78
®
Groundsmaster 300 Series