Wing Shaft End Play - Toro Groundsmaster 300 Series Service Manual

Wing Pulley Brake (Fig. 14)
Raise wing to be adjusted, 15 degrees (use a magneti-
cally mounted compass) and loosen brake pad cap-
screws with an Allen wrench. Push brake pad against
pulley with one hand and tighten capscrews with the
other hand.
NOTE: Idler arm assembly is shimmed to center the
brake pad (vertically) in the pulley groove. Add washers
under the idler arm pivot hub as necessary.
Wing Shaft End Play (Fig. 15)
Slotted holes in the hinge bracket allow for adjustment
of wing shaft end play. End play should be no more than
1/16 inch.
®
Groundsmaster 300 Series
1. Brake pad capscrews (2) per wing 3. Allen wrench
2. Brake pad
1. Slotted wing shaft bracket holes
2. Slotted lift cylinder bracket holes
Page 12 - 11
Figure 14
4. 15° angle
Figure 15
Adjustments