Siemens SINAMICS S120 Getting Started page 43

Hide thumbs Also See for SINAMICS S120:

Table of Contents

3.2

Configuring the drive unit

The following components are required to assemble the drive unit used in this example:

S Active Line Module

S Motor Module

S Synchronous motor (e.g. 1FK6) with sensor for servo control variant

S Induction motor (e.g. 1PH7) with sensor for vector control variant

To assemble the drive unit components, proceed as follows:

1. In the project navigator, open the SINAMICS_CU320 directory and double–click

the element Configure drive unit (see Fig. 3-14).

As you can see in Fig. 3-15, the STARTER opens a Wizard for configuring the

drive unit components.

Fig. 3-15

2. An option board is not used in this example.

Confirm the default setting No option board by choosing Continue > to carry

out the next configuration step.

SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition

Configuration – SINAMICS CU320 option board

Creating the Drive Project OFFLINE

3-43

Table of Contents