Creating the Drive Project OFFLINE
Fig. 3-16
3. In this example, you are using a controlled SINAMICS infeed with DRIVE–
CLiQ connection, an Active Line Module. Confirm the default setting Yes by
choosing Continue >.
Note
If you are using an uncontrolled SINAMICS infeed, click No and then Continue >.
Fig. 3-17
4. Click Continue >.
3-44
Configuration – Introduction to SINAMICS CU320
Infeed configuration
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition
Siemens AG 2006 All rights reserved