Fig. 3-30
26.Check the summary and confirm it by choosing Finish.
As you can see in Fig. 3-31, the configuration Wizard has created the objects
(including Drive_1) for drive unit SINAMICS_CU320 in the project navigator.
Fig. 3-31
27.Save project Project_2 by choosing Project > Save.
Once you have configured the drive unit with STARTER in OFFLINE mode, con-
tinue with the steps described in Chapter 4 "Starting the Drive Project (Motor
Rotates)", where you will set the drive interface parameters and start the motor.
Siemens AG 2006 All rights reserved
SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition
Summary
Project navigator with SINAMICS_CU320
Creating the Drive Project OFFLINE
J
3-53