Siemens SINAMICS S120 Getting Started page 58

Hide thumbs Also See for SINAMICS S120:

Table of Contents

Using the STARTER Control Panel (Motor Rotates)

– When the system informs you that the data was successfully loaded to the

PG, click OK.

7. No further discrepancies are displayed in the ONLINE/OFFLINE comparison

dialog box. Click Close (see screenshot below).

Fig. 4-4

Note

When loading the project, note the LEDs on the Control Unit. The Control Unit is

ready for operation when the LED RDY is continuously lit (green).

This completes the procedure for configuring the drive unit hardware. The following

section shows you how to use the control panel in STARTER.

4-58

ONLINE/OFFLINE comparison, close

SINAMICS S120 Getting Started with the STARTER Commissioning Tool – 03/2006 Edition

Table of Contents