Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 104

Smart Configure of opportunity
The Smart Configure is executed to get and build the configuration
information manually or automatically in the following cases.
• Executing the Smart Configure by the management module console
• Recovering from the N+M cold standby (by BSM Plus or HCSM)
• Turning on the system unit
• Changing the server blade configuration
Executing Smart Configure by management module console
The following operations are performed to execute the Smart Configure by
the management module console.
Executing Smart Configure
This executing Smart Configure is for retaining the configuration of server
blade in the management module after completing the server blade
configuration while SAN boot is enabled.
Executing Smart
Configure
Enabling N+M cold standby
When changing from disabled to enabled for the N+M cold standby, the
Smart Configure is executed to set the Optional Physical WWN in the Fibre
Channel mezzanine card.
Tip: In SMP configuration, each server blade operates with the primary
server blade settings. You need not to perform setting for non-primary server
blades.
Enabling N+M cold
standby
Recovering from N+M cold standby (BSM Plus or HCSM)
When recovering the N+M cold standby failover, the active server blade is not
executed the Smart Configure. The standby server blade is executed the
2-80
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-83 Web console operation
Item
Resources tab > Modules > All Modules > Server Blade >
Server Blade x > Condition tab > Server Blade Action button >
Run Smart Configure
Table 2-84 Web console operation
Item
Resources tab > Modules > All modules > Server Blade >
Server Blade x > Setting tab > Edit Server Blade settings
button
Functional detail
Description
Description