System Unit Settings; Chassis Id - Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual

Note:
• When changing the authentication encryption setting, ensure that
configuration settings such as authentication information are not
changed. If configuration settings are changed while you are changing the
authentication encryption setting, the configuration setting changes will
not be applied.
• Do not change the authentication encryption setting while updating
configuration settings such as authentication information. If you try to
change the authentication encryption setting while updating the
configuration settings, the operation will fail.
• When you change the authentication encryption setting, the management
module restarts and the authentication encryption setting is applied.
• After you change the authentication encryption setting and the
management module restarts, check to make sure the setting has
changed. If the setting has not changed, change the setting again.
• If you disable the authentication encryption setting, the authentication
information is reset to its initial settings. Log in by using the account
registered in the factory default settings, and then set the authentication
information again.
• When downgrading the management module firmware to version A0240
or earlier, make sure the setting for the encryption of authentication
information is disabled.
Tip:
• If you want to change enable the authentication encryption setting, we
recommend that you first back up the configuration settings. By backing
up the configuration settings, in the case that a problem occurs, you can
change the authentication information back to its previous settings before
you changed the authentication encryption setting.

System unit settings

This section describes settings for chassis ID and language.

Chassis ID

The identifier called chassis ID can be registered in the system unit. The
chassis ID can be configured up to 20 characters, and the factory default
setting is used a part of the serial number. The chassis ID can be displayed
followings, and the chassis ID is used to identify the system unit.
• Displaying the system unit connection by the web console, CLI console,
and LCD touch console.
• Displaying ServerConductor/Blade Server Manager in the system unit.
The following tables describe the chassis ID settings.
2-40
Hitachi Compute Blade 500 Series Management Module Setup Guide
Functional detail