Hitachi Fibre Channel Mezzanine Card Settings; Lpar Manager Configuration - Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual

Backing up management
module setting

Hitachi Fibre Channel mezzanine card settings

This subsection describes backing up and restoring settings for Hitachi Fibre
Channel mezzanine cards.
Backing up
The backing up Hitachi Fibre Channel mezzanine card settings is available
from the management module console.
The maximum five generations of Hitachi Fibre Channel mezzanine card
settings for each card are backed up into the management module. When
exporting a backed up Hitachi Fibre Channel mezzanine card settings in the
management module to a peripheral device, select desired card and the
generation, and then export to a peripheral device.
It takes about several minutes.
Note: The backing up is applied for Hitachi Fibre Channel mezzanine card
GG-CC3M8G2X1-Y, GG-CC3M8G2X2-Y, GG-CC3M162X1-Y, and GG-
CC3M162X2-Y. The backing up for the Fibre Channel mezzanine card GG-
CC3M8G1X1-Y and GG-CC3M161X1-Y is not available.
Backing up Hitachi Fibre Channel mezzanine card settings

LPAR manager configuration

This subsection describes backing up and restoring configuration for LPAR
manager.
Backing up
LPAR manager configuration information can be backed up by operating any
of the consoles for the management module. It takes several minutes.
Tip: LP configuration information saved in the management module is output
from the system, such as the management server, etc. For saving LPAR
manager configuration information, see
information on page
2-302
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-166 Web console operation
Item
Resources > Modules > All modules > Management
modules > Action > Restore settings
Table 2-167 CLI console operation
Item
2-142.
Functional detail
Operation
backup blade fc-hba
Saving LPAR manager configuration
Operation