Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 44

• For Hitachi 1 Gb LAN switch module (20-port, 40-port) and Hitachi 1/10
Gb LAN switch module, set the IP address as a network segment other
than that used in another port of the switch module. Setting the IP
address in the same network will fail.
Tip: In SMP configuration, if not using IPMI over LAN, SMASH-CLP, and WS-
MAN for non-primary server blades, you need not to set IP address to the
non-primary server blades. Use 0.0.0.0 by the factory default.
How to set IP addresses
The following tables describe the operations.
Displaying/setting the IPv4
address
Displaying/setting the IPv6
address
Setting/deleting the LAN switch
module authentication
information
Displaying the IPv4 address of management
module
Setting the IPv4 address of management
module
Displaying the IPv6 address of a management
module
Setting the IPv6 address of a management
module
Displaying the IPv4 address of server blade
Setting the IPv4 address of server blade
Displaying the IPv6 address of a server blade
Setting the IPv6 address of a server blade
Displaying the IP address of switch module
Setting the IP address of switch module
Setting the LAN switch module authentication
information
Deleting the LAN switch module authentication
information
2-20
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-26 Web console operations
Item
Resources tab > Systems > Network >
Management LAN > IP Address (IPv4) tab
Resources tab > Systems > Network > Management
LAN > IP Address (IPv6) tab
Resources tab > Modules > All Modules > Switch
Modules > Switch Module x
Table 2-27 CLI console command
Item
Functional detail
Operation
Command
show mgmt-module mgmt-lan
set mgmt-module mgmt-lan
show mgmt-module mgmt-v6 setting
set mgmt-module mgmt-v6 address
show blade mgmt-lan
set blade mgmt-lan
show blade mgmt-v6 setting
set blade mgmt-v6 address
show sw-module mgmt-lan
set sw-module mgmt-lan
set sw-module lansw
authentication
delete sw-module lansw
authentication