Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 107

To perform an N+M failover when a watchdog timer times out, enable the
WDT timeout N+M failover setting. The initial setting (the setting at shipping
time) of the system unit is Disable.
Item
WDT timeout N+M failover
setting
Tip:
• For the Smart Configure runtime, see
2-81.
• When setting the N+M cold standby in LP mode, you need perform the
procedure as above, see
page 2-82 and Enabling N+M cold standby on page
• In SMP configuration, each server blade operates with the primary server
blade settings. You need not to perform setting for non-primary server
blades.
Setting SAN
Server blade in basic mode
WWN is configured by SAN. The Optional Physical WWN is used for WWN.
For confirmation of the Optional Physical WWN, see the following section.
Server blade in LP mode
WWN is configured by SAN. The virtual FC WWN is used for WWN. For
confirmation of the virtual FC WWN, see the Hitachi Compute Blade 500
Series Logical partitioning manager User's Guide.
Tip: Setting SAN is for the FC switch, LUN Manager, or something. For
details, see the document of the FC switch, LUN Manager, or something.
Setting server blade
Server blade in basic mode
To set the active server blade can be booted by SAN.
Fibre Channel mezzanine card setting
¢
- The Fibre Channel mezzanine card BIOS is enabled and the boot
priority is enabled.
For details of setting procedure, see the document of the Fibre
Channel mezzanine card.
- The boot target LU is selected.
For details of setting procedure, see the Hitachi Compute Blade 500
Series EFI User's Guide.
CNA (iSCSI) setting
¢
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-86 Web console operation
Resources tab > Modules > All modules > Chassis
> Setting tab
Setting Smart Configure for server blade on
Functional detail
Description
Smart Configure runtime on page
2-82.
2-83