Hitachi COMPUTE BLADE 500 SERIES Management Module Setup Manual page 85

Displaying the Default Physical WWN
Displaying the currently used WWN
Displaying the Default Physical MAC address
Displaying the currently used MAC address
Tip:
• For Emulex 10 Gb CNA mezzanine card and the onboard CNA, the
following WWN addresses are shown on the Web console or CLI console.
View on the Web console or CLI console (Emulex 10 Gb CNA
mezzanine card / onboard 2-port CNA)
Port shown
on the World Wide Port Name
console
0 World Wide Port Name for port 0 of
controller 0
1 World Wide Port Name for port 1 of
controller 0
2 World Wide Port Name for port 0 of
controller 1
3 World Wide Port Name for port 1 of
controller 1
View on the Web console or CLI console (Emulex 10 Gb CNA onboard
4-port CNA)
Port shown
on the World Wide Port Name
console
0 World Wide Port Name of port 0 of
controller 0
1 World Wide Port Name of port 1 of
controller 0
2 World Wide Port Name of port 2 of
controller 0
3 World Wide Port Name of port 2 of
controller 0
- Since the onboard CNA (2 ports) has one controller, Current WWN and
Default Physical WWN for port 2 and port 3 are not shown on the console.
Hitachi Compute Blade 500 Series Management Module Setup Guide
Table 2-71 CLI console command
Item
Functional detail
Command
Show wwn original
Show wwn current
Show mac original
Show mac current
World Wide Node Name
World Wide Node Name for port 0
of controller 0
World Wide Node Name for port 1
of controller 0
World Wide Node Name for port 0
of controller 1
World Wide Node Name for port 1
of controller 1
World Wide Node Name
World Wide Node Name of port 0 of
controller 0
World Wide Node Name of port 1 of
controller 0
World Wide Node Name of port 2 of
controller 0
World Wide Node Name of port 2 of
controller 0
2-61