CHAPTER 4 MECHANICAL CONSTRUCTION
2.
Removing the Feed Drive Unit
1) Remove the finisher controller PCB (see I-
C-1).
2) Remove the ground lead [1] and the three
screws [2], and pull down PCB base [3] to-
wards you.
3) Remove the harness leads [5] from the two
edge saddles [4], and remove the PCB base.
4-10
Figure 4-121b
[2]
Figure 4-122
[4]
[4]
Figure 4-123
[7b]
[3]
[2]
[1]
[5]