Toshiba MJ-1027 Service Manual page 168

CHAPTER 6 TROUBLESHOOTING
Alignment plate
A4/LT paper
Guide plate
Figure 6-03
8) Press SW1 and SW2 simultaneously to
store the adjustment value (this will low-
er the swinging guide).
9) Shift all bits of SW3 to OFF, and install
the rear cover of the finisher unit.
3. Adjusting the Staple Position
(stapler movement range)
Adjust as follows if you have replaced
the finisher controller PCB. Performing the
steps will affect all paper sizes and all sta-
pling positions.
1) Turn the host machine OFF.
2) Remove the rear cover from the finisher
unit.
3) Set SW3 on the finisher controller PCB
as indicated.
ON
1 2 3 4
Figure 6-04
6-2
07/09
Shift by SW2
Shift by SW1
Stopper
Stopper
5 6 7 8
4) Turn the host machine ON while [0] but-
ton and [8] button are pressed simultane-
ously.
5) If you are using A4 paper, press SW1 on
the finisher controller PCB. If you are us-
ing LT paper, press SW2 on the finisher
controller PCB.
• Pressing SW1/2 will open the swing
guide and cause the feed belt to rotate.
6) Within 5 secs after pressing the switch,
place one sheet of A4/LT paper between
the alignment plate and the guide plate,
butting it against the stoppers.
• When the finisher detects the paper, it
will lower the swing guide and execute
stapling (rear, 1-position). Take out the
stapled paper manually as delivery will
not be executed.
Alignment
Stapler
plate
Guide plate
Figure 6-05
Stopper
Stopper