Table of Contents
Advertisement
CHAPTER 6 TROUBLESHOOTING
10) Measure the distance (L) between the
stitching position and the folding posi-
tion. Then, perform "positive width ad-
justment" or "negative width adjustment"
to suit the relationship between the stitch-
ing position and the folding position.
• If the stitching position is below the fold-
ing position, perform "positive width ad-
justment."
• If the stitching position is above the fold-
ing position, perform "negative width
adjustment."
Positive Width Adjustment
Unit: mm
Example: If L is 1 mm, provide "+1 mm".
Negative Width Adjustment
Unit: mm
Example: If L is 0.5 mm, provide "-0.5 mm".
Figure 6-6
6-6
Mark
Folding position
Stitching position
Mark
Stitching position
Folding position
11) Change the settings of bits 6 through 8 on
DIPSW1 referring to Table 8-102 below.
• If the width adjustment is "0",
The stitching position and the folding po-
sition match, requiring no change.
• If for "positive width adjustment,"
Set DIPSW1 so that the difference result-
ing from subtraction of the interval from
the appropriate setting in Table 8-102 is
provided.
For instance, if the DIPSW1 is currently
set to +2 and the interval is +1 mm, set
DIPSW1 to reflect -2.
• If for "negative width adjustment"
Set DIPSW1 so that the sum resulting
from addition of the interval from the ap-
propriate setting is provided.
For instance, if the DIPSW1 is currently
set to -1 and the interval is +0.5 mm, set
DIPSW1 to reflect +1.
DIPSW1 bit settings
bit 6
bit 7
bit 8
OFF
ON
ON
OFF
ON
OFF
OFF
OFF
ON
OFF
OFF
OFF
ON
OFF
ON
ON
ON
OFF
ON
ON
ON
Do not touch the following:
bit 6
bit 7
bit 8
ON
OFF
OFF
Table 6-02
12) Set bits 1 through 4 on DIPSW1 to OFF.
2.
Stitching Position (adjusting cen-
ter stitching)
Use the host machine adjustment mode
to perform the following:
Settings
(in units of 0.5 mm)
+3
+2
+1
0
− 1
− 2
− 3
Hide quick links:
Advertisement
Chapters
Table of Contents
