Control; Brief Description - Siemens SIMATIC S7-1500 Function Manual
Update 3
Hide thumbs
Also See for SIMATIC S7-1500:
- System manual (523 pages) ,
- Function manual (362 pages) ,
- Manual (188 pages)
Table of Contents
Advertisement
3.15
Control
3.15.1
Brief description
The position controller of the positioning axis/synchronous axis is a closed-loop P controller
with pre-control of velocity.
If the drive supports Dynamic Servo Control (DSC), then a closed-loop position controller in
the drive can optionally be used.
Dynamic Servo Control (DSC)
In drives that support Dynamic Servo Control (DSC), you can optionally use the closed-loop
position controller in the drive. The position controller in the drive is usually implemented with
a rapid speed-control cycle. This improves the control performance for digitally coupled
drives. The communication times between controller and drive are automatically taken into
account.
For DSC, the drive's encoder must be used and standard message frame 5 must be set on
the drive.
See also
Frames (Page 29)
S7-1500 Motion Control V13 Update 3
Function Manual, 07/2014, A5E03879256-AC
Basics
3.15 Control
59
Advertisement
Table of Contents
