Huawei TE40 Administrator's Manual page 154

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Parameter
Presentation
sharing mode
Presentation
plug-and-share
Conference line
type
Conference
bandwidth
Dynamic
bandwidth
reserved
presentation
bandwidth
Issue 01 (2013-09-30)
Description
each site is switched along with the
video. All sites in a conference can
share presentations simultaneously.
NOTE
When connected to an IMS network, the
endpoint cannot share a presentation in Live
mode.

Auto: The endpoint automatically
shares presentations along with
videos. This parameter can be set to
Auto only when Presentation mode
is set to Live.
 Manual: You must manually share
presentations by using the remote
control.
Specifies whether your site
automatically shares presentations with
remote sites once presentation input is
detected.
Specifies the type of line used during a
conference.
If you select Auto and your endpoint has
registered with a network gatekeeper
(GK) server, your endpoint
preferentially uses H.323 to initiate a
conference.
Specifies the transmission bandwidth for
a conference.
Specifies whether the endpoint
implements the following if the packet
loss rate increases due to insufficient
network bandwidth: automatically
decreases the conference bandwidth
until packet loss does not occur
constantly or the conference bandwidth
is decreased to 64 kbit/s. If constant
packet loss is detected, the endpoint can
dynamically adjust bandwidth to recover
stable conference quality within 1
minute.
Disable this parameter if your site is not
going to send or receive presentations
during a conference and the Received
value for Presentation bandwidth
[frame rate] is not -.
If this parameter is disabled, the
Received value for Presentation
bandwidth [frame rate] restores to -
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 Feature Configuration
Setting
The default value is
Manual.
The default value is Disable.
The default value is Auto.
The default value is Normal.
This parameter is not
selected by default.

When the network is
running within normal
parameters, retain the
default value.
 When the network is not
running within normal
parameters, select this
parameter.
The default value is Enable.
146