Huawei TE40 Administrator's Manual page 29

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Parameter
Connection
type
Local IP
address
Subnet mask
Issue 01 (2013-09-30)
Description
network, the endpoint automatically
negotiates with a remote network
device to determine the optimal work
mode.
 10 Mbps and half duplex: The data
transmission rate is 10 Mbit/s, and
data cannot be sent and received at
the same time.

10 Mbps and full duplex: The data
transmission rate is 10 Mbit/s, and
data can be sent and received at the
same time.

100 Mbps and half duplex: The data
transmission rate is 100 Mbit/s, and
data cannot be sent and received at
the same time.

100 Mbps and full duplex: The data
transmission rate is 100 Mbit/s, and
data can be sent and received at the
same time.
 1000Mbps and full duplex: The data
transmission rate is 1000 Mbit/s, and
data can be sent and received at the
same time.
Specifies the mode in which the
endpoint obtains an IP address.

Static IP: The network administrator
assigns an IP address to the endpoint.
If you select this option, you must
also set Local IP address, Subnet
mask, and Gateway address.

Dynamic IP: When a DHCP server
is available on the network, the
endpoint automatically obtains an IP
address using the Dynamic Host
Configuration Protocol (DHCP).
Specifies the endpoint IP address.
Specifies the subnet mask for the
endpoint IP address. A subnet mask
divides the IP address into a network
address and a host address.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Network
Setting
When you do not know the
network port working mode of a
remote network device, set this
parameter to Auto detection.
Otherwise, the endpoint may fail
to access the network.
The default value is Static IP.
The default value is 192.168.1.1
Examples:
 IPv4: 192.168.1.10
 IPv6:
2000:0:0:0:200:55:26:1
Obtain the IP address from the
network administrator.
The default value is
255.255.255.0
Obtain the subnet mask from
the network administrator.
21