Huawei TE40 Administrator's Manual page 32

HUAWEI TE40&TE50&TE60 Videoconferencing
Endpoint
Administrator Guide
Parameter
GK
registration
mode
GK address
Site number
H.323 ID
Authenticati
on user
name
Password
Huawei GK
Issue 01 (2013-09-30)
Description
 Auto: Your endpoint automatically
registers with an available GK on the
network and obtains the GK address.
 Manual: You must set GK address,
which specifies the GK with which
you want your endpoint to register.
Specifies the IP address or domain name
of the server where the desired GK is
installed.
If you set this parameter to the domain
name, you must enable the DNS server
and set correct mapping information on
the server.
This parameter is mandatory only when
GK registration mode is set to Manual.
Specifies the site number for your
endpoint.
If your endpoint registers with a GK,
endpoints that also register with GKs can
dial this site number to call your
endpoint.
Specifies the name by which a GK
identifies your endpoint after your
endpoint registers with the GK.
Specifies the user name used for H.323
authentication.
Specifies the password your endpoint
uses to register with a GK. The GK uses
this password to authenticate your
endpoint.
Specifies whether your endpoint uses a
Huawei GK.
If you do not select Huawei GK, some
functions, such as Conference Control
and SiteCall are unavailable on your
endpoint.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Network
Setting
The default value is Auto.
Example: 192.168.1.10
Enter a string of 1 to 32 digits.
Example: 12345
The name can consist of digits,
letters, and special characters,
such as @ # %.
Example: ab3@
Obtain the user name from your
IP network service provider.
For successful GK
authentication, the name
defined on your endpoint must
be consistent with the name
predefined on the GK.
Obtain the password from your
IP network service provider.
For successful GK
authentication, the password
defined on your endpoint must
be consistent with the password
predefined on the GK.
This parameter is selected by
default.
Do not select this parameter if
your endpoint needs to
interwork with other
manufacturers' devices.
24