Fujitsu ETERNUS CS800 S6 User Manual page 107

Assign the interface to a VLAN (Virtual Local Area Network).
l
Indicate whether the interface IP address will be used to externally identify the system
l
(external host IP address).
Specify the types of traffic allowed on the interface (management, replication, or
l
data).
Specify the NAT address that the interface is mapped to if it is used for replication
l
through a NAT firewall.
Add routing information for an interface to enable connectivity with devices on
l
different subnets.
You can choose to allow any traffic type (management, replication, or data) on
an interface. In this case, the routing of different traffic types, as well as firewall
capability, must be controlled using the network infrastructure (routers and
switches) that the ETERNUS CS800 is connected to.
The iRMC port of the server cannot be configured through the Web GUI of the
ETERNUS CS800. Using the iRMC port is typically not necessary. For example the
hardware monitoring of the iRMC is also included by the monitoring of the
CS800 itself. If you nevertheless want to connect the iRMC to your network, you
have to change its network settings either through the servers' BIOS (see
PRIMERGY RX2540 M1 Server D3289 BIOS Setup
ServerView iRMC Web Server as described in the
Management Controller
The default settings of the iRMC Web Server are:
IP address: 10.17.21.199 with network mask 255.255.255.0 and gateway IP
l
10.17.21.254
login: admin with password admin
l
The service port of the ETERNUS CS800 cannot be configured and should not be
connected to the LAN.
Configuring the network includes the following major steps:
Before configuring the network, work with your network administrator to
determine the network settings that will be required to properly integrate the
ETERNUS CS800 with your company's network.
"Configuring General Network Settings" on page 108
"Network Page: Bonding Details" on page 109
"Configuring Interface Details" on page 110
"Configuring Interface IP Addresses" on page 111
"Configuring Interface Routing" on page 114
ETERNUS CS800
manual).
6.3 Running the Getting Started Wizard
Utility) or through the
iRMC S4 - integrated Remote
107