Fujitsu ETERNUS CS800 S6 User Manual page 300

Figure 207: Network Page: IP Address Table
1. Click Add IP to add a network interface to a device.
Or select an interface to edit the IP address, netmask, gateway and traffic type. (To
select an interface, click the radio button next to the interface index name, for
example, bond0:2.)
A maximum of 10 IP addresses are allowed per device. All IP addresses in
the IP Address Table (added or modified) must be valid and unique, and
must have a valid gateway and netmask.
2. In the VLAN ID column, select the check box to enable VLAN tagging for the interface.
(Or clear the check box to disable VLAN tagging for the interface.)
VLAN tagging allows you to assign an interface to a virtual local area network (VLAN).
With VLAN tagging, you can route different traffic types (management, data, and
replication) over different VLANs, making sure traffic types do not mix.
If VLAN tagging is enabled, enter the VLAN Tag ID for the interface. (Valid values are 2
to 4094. You can assign only one tag ID to an interface.)
Additional Information
The maximum allowed number of VLAN tag IDs is 64. If you attempt to add more
l
than 64 VLAN tag IDs, an error displays.
To maintain connectivity, the switch ports connected to the ETERNUS CS800 must
l
be configured to accept the correct VLAN tag ID.
CAUTION!
If VLAN tagging is enabled for an interface, ETERNUS CS800 Advanced Reporting
is unable to collect and record statistics for traffic moving over the VLAN
interface (for example, eth1.400). Statistics are still collected for the base device
(for example, eth1.)
3. In the External Host IP column, select the check box to designate the interface as an
external host IP. This associates the interface IP address with the host name of the
ETERNUS CS800
10.9 System
300