Fujitsu ETERNUS CS800 S6 User Manual page 302

Additional Information
If the ETERNUS CS800 is configured for source or target replication, you should
l
configure at least one interface to allow replication traffic (select Repl or Any)
before applying changes to network settings.
If you configure segmentation for non-bonded interfaces (Ethernet ports) that are
l
on the same subnet, all traffic will use the lowest numbered Ethernet port first, no
matter how segmentation is configured. To avoid this issue, create bonded
interfaces, and then select the desired traffic type for each bonded interface.
7. Click Update to save the changes you made to the IP Address table. (Clicking Update
does not yet apply the new network settings to the ETERNUS CS800.)
8. Click Delete to remove IP address information for the selected interface. Or click Undo
to revert all current IP Address Table changes to the last update.
When you add a network interface, a default route (via the default gateway)
is automatically created for the interface after network settings are applied
and the ETERNUS CS800 reboots. For example, if you add an interface with IP
address 10.20.185.172, a route with the destination IP address 10.20.185.0
is automatically added. If you delete the default route, it is automatically
added again the next time network settings are applied and the ETERNUS
CS800 reboots. For more information about interface routing, see
on page
Configuring Interface Routing
Some network configurations require that you specify routing details for an interface. You
need to specify routing details if the host or client the interface connects to is on a
different subnet that is not reachable using the default gateway. You also need to specify
routing details if you have configured multiple network segments (replication, data, or
management) on the same subnet. For more information and examples, see
page 293.
Under IP Address Configuration > Routing Details, enter routing information for one or
more interfaces (see
Figure 208: Network Page: Routing Details
1. In the IP Address Table (above routing details), select an interface to add or modify
routing data. (To select an interface, click the radio button next to the interface index
name, for example, bond0:2.)
ETERNUS CS800
293.
"Network Page: Routing Details" on page
"Network"
"Network" on
302):
10.9 System
302