Fujitsu ETERNUS CS800 S6 User Manual page 207

ETERNUS CS800 -
l
Entry - 80 VTD (pre-installed)
o
Scale - 256 VTD (pre-installed)
o
A virtual tape drive is considered active if a cartridge is loaded in the VTD. Make sure
l
to configure the backup application software so that the maximum number of active
VTDs is not exceeded at any time. Exceeding the maximum number of active VTDs may
cause backup jobs to time out.
If you plan to replicate partitions to another ETERNUS CS800, make sure that every
l
partition name and barcode number on each ETERNUS CS800 is unique. There cannot
be duplicate partition names or barcode numbers on the ETERNUS CS800 or on a
ETERNUS CS800 receiving a replicated partition.
CAUTION!
Make sure the backup application on the host is configured for the correct number of
tape drives and storage slots emulated by the VTL partition. If you do not, the
backup application might not operate correctly.
To add a VTL partition:
1. Click Add.
The Add VTL Partition & Replication Settings page displays (see
Replication Settings Page" on page
Figure 150: Add VTL Partition & Replication Settings Page
2. Under Partition Settings, enter information about the partition:
Name
ETERNUS CS800
207).
Enter the name of the VTL partition.
10.3 VTL Configuration
"Add VTL Partition &
207