Fujitsu ETERNUS CS800 S6 User Manual page 208

Library Model
Number of Storage Slots
Virtual Tape Drive Model
Number of Virtual Tape Drives Enter the number of virtual tape drives in the
Enable deduplication -
ETERNUS CS800
Select the library model emulated by the partition.
The library model determines the inquiry string
returned to the host by the ETERNUS CS800. (The
library model does not restrict the number of slots or
drives in a partition because library emulation is not
a representation of a physical library.)
The following library models are available:
Fujitsu CS-TL
l
ADIC Scalar 100, ADIC Scalar i2000, or ADIC Scalar
l
i500
ADIC Pathlight VX
l
Enter the number of storage slots in the partition (up
to 9,000).
One I/E slot is created for each storage slot up
to a maximum of 240 I/E slots.
Select the tape drive model emulated by the virtual
drives in the partition. All virtual tape drives in a
partition must be the same model.The following tape
drive models are available:
IBM LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
l
HP LTO-1, LTO-2, LTO-3, LTO-4, or LTO-5
l
partition.
If all tape drives are currently assigned to other
partitions, you must remove one or more tape
drives from an existing partition to make them
available for use in a new partition.
Select the check box to enable data deduplication.
Fujitsu Technology Solutions recommends that you
enable data deduplication to optimize disk usage.
Data deduplication is enabled by default. You
cannot enable or disable data deduplication
after the partition is added. If data duplication
is disabled, then data compression is also
disabled.
10.3 VTL Configuration
208