Installation And Operation - Fujitsu ETERNUS CS800 S6 User Manual

1.2.3

Installation and Operation

CAUTION!
This unit should not be operated in ambient temperatures above 35 °C.
l
If the unit is integrated into an installation that draws power from an industrial
l
power supply network with an IEC309 connector, the power supply's fuse
protection must comply with the requirements for non-industrial power supply
networks for type A connectors.
The unit automatically adjusts itself to a mains voltage in a range of 100-240 V
l
(50-60 Hz). Ensure that the local mains voltage lies within these limits.
This device must only be connected to properly grounded shock-proof sockets or
l
insulated sockets of the rack's internal power supply with tested and approved
power cables.
Ensure that the device is connected to a grounded shock-proof socket close to the
l
device.
Ensure that the power sockets on the device and the grounded shock-proof
l
sockets are freely accessible.
The ON/OFF button or the main power switch (if present) does not isolate the
l
device from the mains power supply. To disconnect it completely from the mains
power supply, unplug all network power plugs from the grounded shock-proof
sockets.
Always connect the system components and the attached peripherals to the
l
same power circuit. Otherwise you run the risk of losing data if, for example, the
ETERNUS CS800 server unit is still running but a storage subsystem fails during a
power outage.
Data cables must be adequately shielded.
l
The EN 50173 and EN 50174-1/2 standards apply for LAN cabling. The minimum
l
requirement is the use of a category 5 screened LAN cable for 10/100 Mbit/s
Ethernet, or a category 5e cable for Gigabit Ethernet. The requirements from the
ISO/IEC 11801 specification must also be met.
Route the cables in such a way that they do not create a potential hazard (make
l
sure no-one can trip over them) and that they cannot be damaged.
Never connect or disconnect data transmission lines during a storm (risk of
l
lightning strike).
Make sure that no objects (e.g. jewelry, paper-clips etc.) or liquids can get inside
l
the system (risk of electric shock, short circuit).
ETERNUS CS800
1.2 Important Information
15