Network - Fujitsu ETERNUS CS800 S6 User Manual

"Manage Users " on page 331
l
"FC Initiators and Targets" on page 335
l
"Client Plug-Ins" on page 334
l

10.9.1 Network

The Network page allows you to view and change network configuration information for
the ETERNUS CS800. The ETERNUS CS800 uses this information to connect to the network.
Network configuration information is entered during initial setup ETERNUS CS800. You
should consult your network administrator before making any changes to the network
settings.
CAUTION!
Changing the network configuration requires a system reboot to allow all system
services to function correctly. Changing the network configuration requires a system
reboot immediately after the changes are applied.
Rebooting the system can take several minutes. After the new network
configuration is saved, close your Web browser and wait 15 minutes before
logging in again. If you change the IP address that you use to log in to the
system, you will temporarily lose your connection to the remote management
console. Because of this, you might not see a confirmation page informing you
that the new settings have been saved.
To access the Network page, on the System page, click the Network tab (see
Configuration" on page
ETERNUS CS800
294).
10.9 System
"Network
293