Fujitsu M10 Product Notes page 115

Table 3-11 Problems resolved in XCP 2220 (continued)
SPARC M10-
RTI No. 1 4 4S
RTIF2- x x x
140407-004
RTIF2- x x x
140418-001
Description
Suppose you execute the setaudit -a
command to set the user audit policy,
and then reset the XSCF. In this case, the
audit policy of the registered user may be
used as the audit policy of the user
account "default", and the audit policy of
the registered user may be erased. This
occurs when the user account "default"
has no set audit policy.
[Example] Setting an audit policy for
yyyyy user
XSCF> setaudit -a yyyyy=disable
XSCF> showaudit all
--- Omitted ---
User policy:
yyyyy disabled
Events:
AEV_AUDIT_START enabled
XSCF> rebootxscf -a
XSCF> showaudit all
--- Omitted ---
User policy:
default disabled
Events:
AEV_AUDIT_START enabled
The Dynamic Resource Management
(DRM) of Oracle VM Server for SPARC
does not work.
Workaround
If user account "default" is not displayed
for [User Policy:] in the output result of
the showaudit all command, execute the
setaudit -a command to set the audit
policy of the user account "default".
[Example] User account
Set the audit policy for "default".
XSCF> setaudit -a default=enable
[How to restore]
Execute the following procedure.
1. Execute the setaudit -a command to
reset the user audit policy that had
been used as the audit policy of the
user account "default".
2. Execute the rebootxscf(8) command to
reset XSCF.
3. Execute the showaudit all command to
confirm that the set user audit policy is
displayed for [User Policy:].
There is no effective workaround.
Chapter 3 Information on Software 101