2) Please select[f:finish] :
Executing the flashupdate(8) command
■
Do not power on the physical partition (PPAR) during the execution of the
flashupdate(8) command. If you power on the PPAR during the execution of the
flashupdate(8) command, power it on again after the completion of the command.
Upon the completion of the flashupdate(8) command, execute the showlogs event
command to confirm the following message.
XCP update has been completed (XCP version=xxxx:last version=yyyy)
Restoration after the "SCF Diagnosis initialize RTC" error
(RTIF2-131108-001)
[How to restore]
If phenomenon 1 occurs:
■
a. If the Oracle Solaris time has returned to January 1, 2001, execute the setdate(8)
b. If the Oracle Solaris time is other than January 1, 2001, contact a field engineer.
c. If the PPAR power is off, power on the PPAR. After that, check the Oracle
If phenomenon 2 occurs:
■
a. If the Oracle Solaris time has returned to January 1, 2001, it is necessary to
b. If the Oracle Solaris time is other than January 1, 2001, contact a field engineer.
c. If the PPAR power is off, power on the PPAR. After that, check the Oracle
If phenomenon 3 occurs:
■
If phenomenon 1 or 2 also occurs, perform its [How to restore] action first.
Set the Oracle Solaris time again.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240 ・ March 2015
138
command to set the XSCF time again. In this case, the XSCF is reset. After that,
power off and on the PPAR.
In this case, do not execute the resetdateoffset(8) of setdate(8) command on the
XSCF.
Solaris time, and perform the above steps a. or b.
initialize the time difference between the XSCF time and Hypervisor on all of
the PPARs. Stop all the PPARs, and execute the resetdateoffset -a command to
clear the time difference.
In this case, do not execute the resetdateoffset(8) of setdate(8) command on the
XSCF.
Solaris time, and perform the above steps a. or b.