Problems Resolved In Versions Prior To Xcp 2050 - Fujitsu M10 Product Notes

b. If the Oracle Solaris time is other than January 1, 1970, contact a field engineer.
c. If the PPAR power is off, power on the PPAR. After that, check the Oracle
If phenomenon 3 occurs:
■
If phenomenon 1 or 2 also occurs, perform its [How to restore] action first.
Set the Oracle Solaris time again.

Problems resolved in versions prior to XCP 2050

The following table lists the problems resolved in versions prior to XCP 2050.
Table 3-21 Problems resolved in versions prior to XCP 2050
SPARC M10-
RTI No. 1 4 4S
RTIF2- x x x
121113-001
RTIF2- x x x
121113-002
RTIF2- x x x
121113-006
RTIF2- x x x
121113-007
the PPARs. Stop all the PPARs, and execute the resetdateoffset -a command to
clear the time difference.
In this case, do not execute the resetdateoffset(8) of setdate(8) command on the
XSCF.
Solaris time, and perform the above steps a. or b.
Description
After setting an invalid value for the user
name with the setsmtp(8) command, you
execute the setemailreport(8) command
to send a test mail. Then the reply
address shows that the mail has been
successfully sent.
If you execute the setaudit delete
command and use the viewaudit(8) to
display the audit log, some audit logs
may not be deleted.
If you display the XSCF Web screen in
another window or in another tab
without using the XSCF Web menu,
contents may not be normally displayed.
While XSCF is starting, process down,
panic or watchdog timeout occurs, which
may cause XSCF to be reset.
Workaround
There is no effective workaround.
Even if it is displayed that the test mail
has been successfully sent, it is not sent.
There is no effective workaround.
For operation to display the XSCF Web
screen, use the menu tree.
Confirm that XSCF is successfully started.
If it is not started, turn off the power of
the physical partition (PPAR), and then
disconnect the input power supply to the
system and back on again (AC OFF/ON).
When recycling the power supply to the
system, wait for 30 seconds or more to
turn on the input power supply after
disconnecting.
In case XSCF is not started even if
recycling the input power supply to the
system, replace the CPU memory unit
lower (CMUL) or the motherboard unit
(MBU).
Chapter 3 Information on Software 145