Fujitsu M10 Product Notes page 185

Table 3-25 Problems resolved in Oracle Solaris 11.2 (continued)
SPARC M10-
Bug 1 4 4S
15840018 x x x
15851224 x x x
15851441 x x x
Description
When the firmware is updated to
XCP2031 or later, the following message
is displayed when starting Oracle Solaris.
NOTICE: skipping unsupported token:
fjorclnum
When starting the I/O domain, the
following message may be output and
the panic may persist.
recursive rw_enter, lp=XXXXXXXX
wwwh=XXXXXXXX thread=XXXXXXXX
When the memory fails and is degraded,
the following message may be output at
startup of Oracle Solaris, and the panic
may persist.
tilelet_assign_fini_cb(): tile 0xX in
memgrp X was unused
This may also occur when you set the
mirror mode for the memory after saving
the logical domain setting with ldm
add-spconfig.
Workaround
This has been modified with SRU11.1.6.4.
0, and the patch 148888-03 for Oracle
Solaris 10.
Ignoring this message does not have an
impact on the system.
This has been modified with SRU
11.1.12.5.0, and patch 150840-01 for
Oracle Solaris 10.
Add the following to /etc/system of the
I/O domain and restart Oracle Solaris:
forceload: drv/vpci
Note that if starting of the I/O domain is
disabled, you must change to inactive
state the guest domain to which the
virtual disk (vdisk), which is a target of
the virtual disk service (vds) of the I/O
domain, is assigned, with the ldm
stop-domain and ldm unbind-domain
commands. This will enable starting of
the I/O domain. After starting the I/O
domain, set the above.
This has been modified with SRU11.1.11.
4.0.
For details, see "If Oracle Solaris is
activated during memory degradation, a
panic may occur (CR:15851441)."
Chapter 3 Information on Software 171