Fujitsu M10 Product Notes page 63

Table 3-5 Problems that might occur with XCP 2240 and workarounds (continued)
SPARC M10-
RTI No. 1 4 4S
RTIF2- x
131213-012
RTIF2- x x x
131213-014
Description
After replacing SPARC M10 with the
replacefru(8) command, diagnosis
processing may not terminate properly.
[Example]The replacement of BB#2:
Diagnostic tests for BB#2 have started.
Initial diagnosis is about to start,
Continue?[y|n] :y
PSB#02-0 power on sequence started.
0.....30.....end
Initial diagnosis started. [7200sec]
0..... 30..... 60..... 90.....120.....150.....180.....
210.....240.....
270.....300.....330.....360.....390.....420.....450
.....480.....510.....
540.....570.....600.....630.....660.....690.....720
.....750.....780.....
810.....840.....870.....900..end
Initial diagnosis has completed.
PSB power off sequence started. [1200sec]
0..... 30..... 60..... 90.....120.....150.....180.....
210.....240.....
270.....300.....330.....360.....390.....420.....450
.....480.....510.....
540.....570.....600.....630.....660.....690.....720
.....750.....780.....
810.....840.....870.....900.....930.....960.....990
.....1020.....1050.....
1080.....1110.....1140.....1170.....1200end
Failed to power off. Please check the FRU.
An internal error has occurred. Please
contact your system administrator.
done
[Warning:030]
testsb failed.[c:cancel] :
If the time zone of XSCF is changed using
the settimezone(8) command, the time
zone of Oracle Solaris on that physical
partition, which is booted after the
change, gets misaligned to the tune of the
time difference before and after changing
the time zone of the XSCF.
[Example]
If the time zone before setup was UTC
and after setup is JST, the time
misalignment of Oracle Solaris will be 9
hours.
Workaround
There is no effective workaround.
[How to restore]
Re-execute the replacefru(8) command.
There is no effective workaround.
Boot the Oracle Solaris after executing
the resetdateoffset(8) command and set
to the right time on the Oracle Solaris.
Chapter 3 Information on Software 49