Notes And Restrictions; Notes On Secure Socket Layer (Ssl) 3.0; Restrictions On Audit; Notes On Dynamic Reconfiguration Of Physical Partitions - Fujitsu M10 Product Notes

Notes and Restrictions

This section describes notes and restrictions that are known as of this release.

Notes on Secure Socket Layer (SSL) 3.0

For security reasons, you cannot use SSL 3.0 with XCP 2240 or later.
Use Transport Layer Security (TLS) 1.0.

Restrictions on audit

The log file transfer function of the audit log set with the setaudit archive
■
command and the setaudit disable command is not supported at present.
If the policy for writing to an audit record is set to stop temporarily ("suspend"),
■
degradation due to an error may occur or the XSCF may be reset. In the setaudit(8)
command, specify overwriting ("count") by default for the write policy for the
audit trail. For details of this problem, see "RTIF2-141208-001."
Notes on dynamic reconfiguration of physical
partitions
In case of dynamic reconfiguration of physical partitions, when adding an I/O
■
device, it is necessary to either stop the domain or use the delayed reconfiguration
feature to integrate the I/O device into the logical domain, after executing the
addboard(8) command.
Moreover, when removing an I/O device, after removing the I/O device by
stopping the domain or using the delayed reconfiguration feature, execute the
deleteboard(8) command in order to disconnect the system board. For details on
each procedure, refer to the Fujitsu M10/SPARC M10 Systems Domain Configuration
Guide.
Note that you can add and delete I/O devices without stopping the logical
domains and without delayed reconfiguration on Oracle Solaris 11.2 SRU11.2.8 or
later.
After dynamic reconfiguration of a physical partition, the execution results of
■
prtdiag(1M) command executed from the control domain may differ from the
actual physical configuration.
Executing "svcadm restart picl" can update to the latest information.
While adding or removing system boards with the addboard(8) or deleteboard(8)
■
command of the DR feature, do not reboot all the XSCFs with either the
"rebootxscf -a" command or from the XSCF Web interface. If such an operation is
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240 ･ March 2015
12