Drive-Cliq Signal Cables Without 24 V Dc Cores; Drive-Cliq Signal Cables Motion-Connect With Rj45 Connectors - Siemens Sinamics S120 Manual

Cabinet design and EMC Booksize
12.8 Connection systems
12.8.1.2

DRIVE-CLiQ signal cables without 24 V DC cores

Pre-assembled DRIVE-CLiQ signal cables without 24 V DC cores are used to connect
components with DRIVE-CLiQ connection, which have a separate or external 24 V DC
power supply. They are mainly intended for use in control cabinets. The signal cables are
available with RJ45 connectors in degrees of protection IP20 and IP67.
Table 12- 13 Actual lengths of the DRIVE-CLiQ jumpers for Line Modules and Motor Modules
DRIVE-CLiQ bridge
50 mm
100 mm
150 mm
200 mm
250 mm
300 mm
350 mm
1)
Cable lengths from 600 mm and higher are used to connect to other applications (e.g.
establish a 2nd line in the drive line-up, establish wiring in a star configuration etc. )
Figure 12-22 DRIVE-CLiQ signal cables without 24 V DC cores (IP20)
12.8.1.3

DRIVE-CLiQ signal cables MOTION-CONNECT with RJ45 connectors

The MOTION-CONNECT DRIVE-CLiQ signal cables with RJ45 plugs have 24 V cores. They
are used for components with DRIVE-CLiQ connection if higher requirements must be
complied with, such as mechanical stress and resistance to oil. For example, the signal
cables are used for connections outside the control cabinet:
● Connections between Motor Modules and Sensor Modules
● Connections between Motor Modules and motors with DRIVE-CLiQ interface
The maximum length of the DRIVE-CLiQ MOTION-CONNECT signal cables with RJ45 plugs
is:
● 100 m for MOTION-CONNECT 500 cables
● 75 m for MOTION-CONNECT 800PLUS cables
The signal cables are available in degrees of protection IP20 and IP67.
732
Cable length without connector
Cable length L
1)
110 mm
160 mm
210 mm
260 mm
310 mm
360 mm
410 mm
Manual, (GH2), 04/2014, 6SL3097-4AC00-0BP6
Booksize Power Units