Connecting Bus Cable To Bus Connector (6Es5 ...) - Siemens SIMATIC S5 Manual

1. Connect the bus cable as shown in Figs. 5-9 and 5-10 by connecting the
Figure 5-10 Connecting bus cable to bus connector (6ES5 ...)
2. If the bus connector is at the start or end of a segment, you must activate
3. Place the cover in position and tighten the securing screws.
ET 200 Distributed I/O System
EWA 4NEB 780 6000-02a
Routing cables; connecting and installing bus connectors
same cores to terminal A or B (e.g. always connect green conductor to
terminal A and red conductor to terminal B).
Bus-cable connection for first
and last stations on the bus
Naked shield must be
seated on metal guide
Switch in "ON" position
(terminating resistor in circuit)
the terminating resistor (set the switch to "ON") (see Fig. 5-10).
Make sure that the naked cable shield is seated under the shield clamp.
Bus-cable connection for all
other stations on the bus
Terminating resistor
not in circuit
5-21
5