Siemens SIMATIC S5 Manual page 325

redundant remote operation, Glossary-8
reference potential, Glossary-8
regulations for operation of the ET 200, 5-3
relative humidity, A-4
release status of components described in
manual, iii
remote operation, redundant, Glossary-8
repeaters on bus, bus parameters, 8-7
replacing the 32 K EEPROMs, 4-10
reserve inputs, host parameters, 8-10
reserve outputs, host parameters, 8-10
response monitoring, Glossary-8
for slaves, master parameters, 8-13
slave parameters, 8-14
response monitoring time/Ttr, bus parameters,
8-7
response of ET 200, 12-5
RFI suppression, A-2
routing cables
in-building, 5-5
notes, 5-2
routing of cables, notes, 5-2
RS 485 repeater, Glossary-9
block diagram, 6-5
configuration options, 6-6
connecting bus cable, 6-12
connecting the power supply, 6-11
definition, 6-2
definition and mechanical design, 1-18
dimensional drawing, E-5
grounded/non-grounded operation, 6-10
installing, 6-8
mechanical design, 6-3
pin assignment PG/OP interface, 6-5
rules, 6-2
setting terminating resistor, 6-6
technical data, 6-4
using, 6-2
rules for operation of the ET 200, 5-3
RUN, Glossary-9
operating mode of IM 308-C, 11-7
RUN LED. See LED "RUN"
ET 200 Distributed I/O System
EWA 4NEB 780 6000-02a
S
S5-95U
address areas, 10-2
appearance, 4-2
control processor failure, 12-12
controls and LEDs, 4-2
cycle checkpoint, 12-12
data consistency, 10-3
default parameter set, 12-4
definition and functions, 1-10
design, 4-2
exchange of data between S5-95U and DP
slaves, 4-6
functions of the communication processor,
4-6
functions of the control processor, 4-6
installing, 4-10
message in operating system datum, 12-4
monitoring time, 12-12
power-up on the bus, 12-3
response to failure, 12-12
technical data, 4-8
S5-95U with SINEC L2-DP interface, 1-12
save, to memory card, 8-25
saving, to 32 K EEPROM, 8-26
saving the file, example, 7-13
saving with COM ET 200 Windows, 8-24
segment, Glossary-9
set parameters, bus parameters, 8-7
shared-input master, Glossary-9
assigning, 8-19
definition, 8-19
preconditions, 8-19
shared-input slaves, definition, 8-19
shield impedance, Glossary-9
shielding of cables, 5-9
short-circuit, Glossary-9
SINEC L2, Glossary-9
SINEC L2-DP, 1-3, Glossary-9
characteristics, 1-13
SINEC L2-DP field bus. See SINEC L2–DP
slave, Glossary-9
slave diagnostics, 9-12, 10-4
definition, 9-15, 10-6
requesting, 9-15, 10-6
structure, 9-17, 10-7
structure for DP standard slaves, 9-19
slave parameters
definition, 8-14
entering, 7-11, 8-15
meanings, 8-14
Index
Index-7