Siemens SIMATIC S5 Manual page 3

Introduction
Purpose of the
manual
Applicability of the
manual
ET 200 Distributed I/O System
EWA 4NEB 780 6000-02a
The information in this manual will enable you to:
set up the SINEC L2 DP bus
parameterize the configuration of the ET 200 distributed I/O system with
the COM ET 200 Windows software
operate the IM 308-C as DP master and/or DP slave
operate the S5-95U with DP master interface on the SINEC L2 DP bus
start up the SINEC L2 DP bus
This manual deals with the S5-95U programmable controller and
supplements the system manual S5-90U/S5-95U Programmable Controller. It
describes all the functions and features of the DP master interface of the
S5-95U.
This manual is applicable to:
Module /
software
IM 308-C 6ES5 308-3UC11
S5-95U 6ES5 095-8ME01
COM ET 200 6ES5 895-6SE.2
Windows
RS 485 repeater 6ES7 972-0AA00-0XA0
SINEC L2 bus con- 6ES5 762-2AA12 /-2AA21
nectors
6ES7 972-0B.10-0XA0
6ES7 972-0B.20-0XA0
FB IM308C (FB 192) Shipped on diskette together with
with demo program COM ET 200 Windows
This manual describes all the modules approved at the time of issue. We
reserve the right to enclose a Product Information Sheet containing
up-to-date information with each new or revised module.
Order number As of release/
version
3
1
2
1
1
1
1
1
iii