ABB i-bus KNX Product Manual page 91

®
ABB i-bus KNX
Commissioning
Enable next sequence step assignments
Options:
With this parameter, a further sequence step can be enabled. A maximum of 10 steps are possible.
no: No further sequence step is enabled.
yes: A further sequence step is enabled.
Brightness value and the group member
will defined in the scene
< NOTE
Time duration in s [0...65,535]
Options: 0...300...65,535
In this period, the lighting groups of this sequence step assume the parameterized brightness val-
ues in the scene.
no limitation: The brightness value (scene values of the lighting group) remains set for an unli-
mited period. The brightness value is only changed if a new telegram is received via the KNX.
Time duration changeable via
obj. "Flexible time" 2 Byte
Options: yes
no
The time received via the communication object Flexible time has an effect on the time duration of
the sequence. The flexible dimming time has a value between 0...65,535 seconds.
yes: The time received via the central communication object (DALI output) Flexible time is used
for the time duration of the sequence.
no: The time duration for the sequence cannot be changed via KNX.
For further information see Communication object no. 27 page 112.
yes
no
DGN/S 1.16.1 | 2CDC 507 114 D0201 89