Parameter Window - Gx Status - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
3.2.2.4 Parameter window – Gx Status
In this parameter window, the status response of the selected lighting group is parameterized.
Each lighting group is individual and can be programmed independently of the other lighting groups. The
parameterization relates to the communication objects of the lighting group (Group x).
The status behaviour of the entire DALI output, see
of the parameterization of the status response of the lighting group.
Status response of switching state
of the DALI output
Options:
no: The status of the switch state is not actively sent on the KNX.
yes: via object "Switch/status": The common communication object Switch/status receives the switch
telegram, and the current status becomes active and is sent on the KNX.
yes: via separate object "Status switch": An additional Status switch communication object is enabled.
Using it, a 1 bit telegram with the actual switch status is sent on the KNX.
Note
This status message relates to all connected devices of the lighting group.
With a change of the parameterization or after a subsequent switching of the status object, the assign-
ment of the group addresses already allocated to the communication object Switch is lost and needs to
be reprogrammed.
If the communication object Switch/status is used for switching and status feedback, particular care
must be taken with the read and write properties (flags) of the communication objects.
For further information see:
60 2CDC 507 114 D0201 | DGN/S 1.16.1
no
yes: via object "Switch/status"
yes: via separate object "Status switch"
Common communication object for control telegram and
Parameter window - Status, page 42, is independent
status, page 103