Parameter Window Sequence - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Commissioning
3.2.5

Parameter window Sequence

The parameter window Sequence, in which the sequence of the scenes and the number of repetitions is
set, is enabled if in
curve per gateway) is set with the option yes.
The DGN/S offers the possibility of allowing a sequence to be run.
A sequence is a string of up to a maximum of ten scenes, which are recalled successively. The recall of
the lighting groups involved is undertaken via the communication object Switch or Switch/status of the ligh-
ting group. Furthermore, the set sequence can be repeated up to 255 times. If required, endless repetition
of the sequence can be parameterized. In this way, it is possible to program running lights on the device
without additional logic or timer modules, for example, for effect lighting, facade lighting, in shop presenta-
tion or exhibition areas.
Note
Only one sequence can be programmed on the DGN/S. The setting is undertaken in the parameter
window Sequence. The sequence is recalled by any lighting group if the additional function Sequence is
selected for this lighting group. This parameterization is undertaken in
page 51.
For further information see: Sequence, page 142
The definition of the scenes is undertaken in the
via the parameter Enable function Scene in the parameter window
and then is subsequently enabled in
With running function Sequence, the lighting group follows the predefined sequence. The reaction to
switch, dimming or brightness value telegrams during ongoing function Sequence can be parameterized
individually in the
Parameter window General, page 27, the parameter Enable sequence time curve (one
Parameter window Scenes
Parameter window - Gx Sequence, page 74.
Parameter window Gx
Parameter window Scene x on page 85, which is enabled
Parameter window
on page 84.
DGN/S 1.16.1 | 2CDC 507 114 D0201 87
Group,
General, page 27,