Mitsubishi Electric MELSEC iQ-R Series User Manual page 143

Step action wave output request
Set whether to execute the step action wave output for all the analog output channels in a batch.
Step action wave output request
OFF
ON
The setting for this area is enabled only in the wave output mode. In other modes, changing the setting value is ignored.
When the setting value is changed from OFF (0) to ON (1), the wave output status in all the channels, where the D/A
conversion is enabled, is changed to During wave output step action and the wave output step action function is enabled.
When the setting value is changed from ON (1) to OFF (0), the wave output status is changed to During wave output stop and
the wave output step action ends.
When a value out of the setting range is set, a step action wave output request range error (error code: 1D80H) occurs and
the wave output status is not changed.
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Step action wave output request
Step action wave output request (When the Q
compatible mode function is used)
■Default value
The default value is OFF (0).
Interrupt factor generation setting [n]
Set an interrupt request for when the same interrupt factor occurs during the interrupt factor detection.
Setting value
0
1
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is Interrupt resend request (0) and the same interrupt
factor occurs during the interrupt factor detection, an interrupt request is sent to the CPU module again.
• When 'Interrupt factor generation setting [n]' (Un\G200 to Un\G215) is No interrupt resend request (1) and the same
interrupt factor occurs during the interrupt factor detection, an interrupt request is not sent to the CPU module.
If a value other than the above is set, an interrupt factor generation setting range error (error code: 180H) occurs.
"n" and  indicate an interrupt setting number. (n = 1 to 16,  = 0 to F)
■Buffer memory address
The following shows the buffer memory address of this area.
Buffer memory name
Interrupt factor generation setting
[n]
Interrupt factor generation setting
[n] (When the Q compatible mode
function is used)
■Enabling the setting
Turn on and off 'Operating condition setting request' (Y9) to enable the setting.
■Default value
The default value is Interrupt resend request (0) for all buffer memory areas.
CH1 CH2
188
1072
1 2 3 4 5
200 201 202 203 204
4096 4097 4098 4099 4100
Setting value
0
1
CH3 CH4 CH5
Setting content
Interrupt resend request
No interrupt resend request
6 7 8 9 10
205 206 207 208 209
4101 4102 4103 4104 4105
CH6 CH7 CH8
11 12 13 14 15
210 211 212 213 214
4106 4107 4108 4109 4110
APPENDICES
Appendix 3 Buffer Memory
A
16
215
4111
141