Mitsubishi Electric MELSEC iQ-R Series User Manual page 50

Item Setting result
Logarithmic The graph is drawn with an adjustment so that the start point and end point are on the edge points of the logarithmic function of y = log
function = 1 to 101).
*1
Sine function The interval between the start point and end point is drawn in a sine function wave. The amplitude A of the sine function to be drawn is the
value set in "Amplitude". The start position can be changed by 180 by setting "Phase".
Number of data in a wave pattern: Wx
Digital value range: Wy
Data position of the start point: Xst
Data position of the end point: Xed
Cosine The interval between the start point and end point is drawn in a cosine function wave. The amplitude A of the cosine function to be drawn is
*1
function the value set in "Amplitude". The start position can be changed by 180 by setting "Phase".
Number of data in a wave pattern: Wx
Digital value range: Wy
Data position of the start point: Xst
Data position of the end point: Xed
*1 When using the sine function and cosine function, set the same digital value for the start point and end point.
7.
Drag the created end point to adjust the position.
The end point position also can be adjusted by changing the value of "End point" and "Digital value" in "Wave details setting".
Item
Start point
End point
Digital value
1 FUNCTIONS
48
1.14 Wave Output Function
Drag
Description
The end point of the previous interval is displayed. To change the start point, change the end point of the previous interval.
Set the number of data (position) for the destination end point. Note that the section No.1 cannot be changed because it is the first
point of the wave pattern.
Set the digital value for the destination end point.
Start point
Start point
Wx
Xed-Xst
Wx
Xed-Xst
X (X
e
End point
End point